The operation of the airflow grinder, many people think that only on, off, but in order to ensure the normal work of the airflow grinder, in its different operation links, the corresponding operation sequence has strict provisions. The following small series to teach you how to correctly operate the airflow crusher.
Preparation before starting
Check the host, attached machine, pipes and valves to see if they are intact and can work normally.
(1) Turn on the power supply of the compressor, the pressure valve of the dust collector and the main air valve in turn, and then turn on the power switch of the airflow crusher to switch on the power supply.
(2) Start the grading wheel from zero and gradually adjust it to the specified speed.
(3) Turn on the fan, cyclone separator discharging, dust discharging and feeding motor power in turn, then turn on the general power supply of the feeding bin, set the frequency of the frequency converter, and then start feeding for crushing.
(4) The granularity of finished products can be adjusted by grading wheel frequency and feeding amount.
Stop sequence: frequency converter - feeder - main air valve - compressor - classification impeller motor - cyclone discharge, dust discharge switch - fan - main power supply - air compressor.
(1) The motor should be lubricated regularly, but the lubricating grease should not be excessive to avoid the bearing temperature being too high.
(2) The wear of classifying impeller, spiral feeder and crushing nozzle should be checked, and the tightness of the transmission belt should be appropriate.
(3) After crushing materials to a certain time, it is necessary to clean the attached powder inside the machine to avoid blockage, thus affecting the crushing effect.
(4) After the filter bag has been used for a period of time, it should be cleaned or replaced.
(1) When the unloading device is running, the unloading outlet should not be extended to avoid accidents.
(2) The speed of the impeller can not exceed the specified, otherwise the temperature will be too high, damage the impeller and the motor.
(3) Safety valves should be checked regularly to ensure safety.
Have you remembered the operation method and matters needing attention of different use links of airflow grinder? If you still have what do not understand, you can also continue to pay attention to our official website, we will present more wonderful content for you.
Shanghai Huasan Powder Equipment Co., LTD
Contact person: Manager Zhu
Mobile phone: 13818804871/18017628352
Address: No.33 puzhuang Road, Zhuanghang European Industrial Park, Fengxian District, Shanghai