What are the main advantages of high performance horizontal mixer?

The advantages of horizontal mixer are as follows:

1, continuous material in and out, high mixing degree

The structure of horizontal mixer is single-axis and multi-rake teeth design, and the rake teeth are arranged in different geometric shapes, so that the material in the whole mixer body is thrown into the material curtain before and after movement, so as to realize the cross mixing between materials.

This mixing mechanism is especially suitable for the mixing of powder and powder, can also be used for powder and a small amount of liquid (binder) between the mixing, or the mixing of materials with a large proportion difference.

2. The equipment works stably

Horizontal mixer is in horizontal structure. The material to be mixed is fed into the mixer through the belt and mixed forcefully by the mixing tool. The mixer barrel body is equipped with rubber lining plate to prevent adhesion. The mixing tool is made of high wear-resisting steel and wear-resisting welding rod, with long service life. The mixer has been used on site for many years, and the practice proves that the structure design is reasonable, the work is stable and the maintenance is convenient.

Three, strong sealing, small impact on the environment

Horizontal mixer is a horizontal closed cylinder structure, the inlet and outlet of the material is easy to connect with the dust removal equipment, and the environmental impact on the mixing area is small.

There will be violent vibration when the cone mixer is not used properly. At this time, in order to protect the cone mixer, we need to solve the problem through our own ability. The following is to introduce the misunderstandings in this regard:

(1) The maintenance hammer component is incorrectly installed. Hammer change is used to prevent the weight of the rotor from losing balance. All changes in the hammer crusher must face the face together in reverse, during operation, otherwise strong vibration will occur.

(2) The difference between the two groups corresponds to a hammer weight of more than 500 grams. What is excluded is adjusting the weight of the hammer so that the weight difference between the groups is less than 5 grams.

(3) individual hammer card is too tight, do not run off. You can use your hands to stop to observe and turn over, and find a way to make the hammer turn flexibly.

(4) Other weight parts of the rotor is not balanced, then need to carefully examine and adjust the balance.

(5) Axis bending deformation, need to straighten or replace.