What are the classification of horizontal mixer in Shanghai?

Horizontal screw belt mixer

Double axis horizontal mixer is to stir dry, powdery materials, to stir and mix evenly. Mixing time in the material by two opposite direction of the rotor movement, with complex movement, biaxial blade material along the machine drive slot wall to do good or poor two clockwise, near the axis of the material do the axis of rotation, axial on both sides to promote from within, outside screw drive close to the wall material do the axis of rotation, the axial by both sides to promote, Therefore, the convection circulation and shear infiltration in the material cylinder can complete the rapid and uniform mixing of the material in a short time. Product features :1. Using u-shaped barrel structure, smooth operation, uniform mixing, no dead Angle, clean discharge, wide application range. 2. Using inside and outside double screw belt staggered mixing, mixing speed, high uniformity 3. Bearing at both ends of mixer, material is not easy to enter, low maintenance rate. 4 screw conveyor feeding convenient, feeding mouth flush with the ground, feeding labor-saving convenient. 5. Internal structure and overall design materials through the ISO9001 international quality system certification. Working principle: this machine is composed of two parts: feeding and mixing. Feeding part: enter from the hopper and lift the material to the mixer through the spiral blade into the mixing drum for mixing. 2. Mixing part: when the material enters the mixing cylinder for staggered movement, mixing and mixing effect is good.

Three dimensional swing mixer

The working principle of the TURBULA mixer is different from that of the traditional rotary mixer. In three-dimensional cube space, the TURBULA moves, moves, and rocks the material in the mixing cylinder in a complicated motion state of "rotating flow-translating-inverted falling". Generate an alternating pulse, continuously promote the material, the movement of the turbulence is a change of energy gradient, so that the mixed material in each particle can not have the motion state, each particle in frequent motion diffusion constantly change their position, have a satisfactory mixing effect. Three-dimensional swing mixer is composed of frame, drive system, three-dimensional motion mechanism, mixing barrel and electrical control system, etc. The mixing barrel in direct contact with the material is made of high quality stainless steel material, and the inner wall of the barrel is precisely polished. Series three dimensional swing is a novel material mixer widely used in pharmaceutical, chemical, food, light industry and scientific research institutions. This machine can mix powder or granular material with good flow performance very evenly, so that the mixed material can achieve the best effect. Performance features :1, with multi-direction movement, so that the material in the cylinder body mixing points, mixing effect is significant, the mixing uniformity is higher than the general mixing machine uniformity; 2. The inner wall of the body of the mixing cylinder of the THREE-DIMENSIONAL swing mixer is precisely polished; 1. The machine is unloaded, loaded and tested before leaving the factory. After normal operation, it can be delivered to meet users' safety. 2, mode of transport :600 litre (including 600 type) using the whole machine factory, no preparation of feet, bolts; 600 vertical lift above the use of split transport, preparation of feet, bolts. 1, the machine adopts electromagnetic speed regulation (or frequency converter speed regulation), before starting, switch on the main power supply, power indicator light, and then start the motor button, and then start the speed control panel on the switch (frequency converter can touch the button), the indicator light, and then slowly rotate to reach the normal mixing speed; 2. If the user needs temple mixing time, this content should be stipulated in the contract. Our factory may install time relay so that the user can specify mixing time according to the mixing requirements of materials. 3. After the mixing, turn off the machine according to the startup sequence. If the blanking is not ideal, you can click the button to meet the blanking requirements.