Characteristics of pepper crusher

Pepper crusher, also known as pulverizer, is mainly applicable to pharmaceutical, chemical, food and other industries, suitable for crushing low hardness materials. Relying on the advantages of simple structure, strong, smooth operation, crushing material fast, uniform, good effect to break the new generation of crusher. The pepper crusher is made of fine stainless steel, and the surface is smooth and easy to clean. Changed the common grinding machine inner wall rough, easy to accumulate powder, difficult to clean up the phenomenon, so that food, medicine, chemical production can meet the national standards, GMP health requirements.

Pepper crusher has the following characteristics:

1. Simple structure, easy to assemble and disassemble, easy to clean.

2. Smooth operation, low noise.

3. Simple operation, change the screen can control the size of particle size.

Structure and working principle of Pepper crusher:

Pepper crusher is composed of feeding mouth, switch, fixed tooth plate, screen, rotary tooth plate, crushing cavity, discharge mouth and other parts. The machine uses the relatively high speed operation between movable tooth plate and fixed tooth plate, so that the crushed material can be crushed by the impact and friction of tooth plate and the collision between materials. Pulverized material can be directly discharged from the grinding chamber, through the discharge port, general materials after grinding to be collected through the cotton bag, pulverized material collected in the bag, air from the small holes in the bag, will not be fine powder discharge, so as to play a waste, no pollution effect. This machine is equipped with screen mesh, screen mesh can be changed according to customer requirements. The coarse material continues to grind. Zanthoxylum pulverizer has high grinding efficiency and can reduce the loss of materials in the grinding process. Even crushing particle size, under the better load of the machine, there will be no uneven crushing particle size phenomenon.

Introduction of water cooling device of Pepper mill:

According to the special requirements of users and the special physical and chemical properties of crushed materials, the pepper crusher can be equipped with water cooling device. If the melting point of the crushed material is low, low ignition point, easy to become soft and sticky when heated, thus reducing the crushing effect or unable to crush, and even cause combustion and explosion, it is necessary to install water cooling device on the crushing equipment. This machine is not suitable for crushing viscous materials and materials with high oil content. The commonly used water cooling device is to install a sealed water clip on the front and back wall of the crushing chamber, so that the flowing tap water or well water constantly flows into the rear wall water clip, and then flows into the front wall water clip, and then flows back into the rear wall by the front wall water clip, and then flows out of the water outlet of the rear wall. The purpose of the water cooling device is to reduce the temperature of the comminution chamber!